UV weathering chamber This product is suitable for use on a variety of materials testing methods fluorescent light exposure to ultraviolet light method, mainly on the material placed outside of change and durability testing of new materials and products, such as improved formulation. Purple fluorescent lamp installed outside: UV lamps are fragile, and therefore separate packaging factory, the installation should be especially careful to avoid unnecessary losses. After the device is powered down when installing trial opened on both sides of the cover and lamp replacement port, ultraviolet fluorescent positive seal insert, and then push the tube to tube being inserted into the other side of the ring, and finally adjust lights pipe sealed at both ends caps, fitted lamp power connectors. Note the use tube surface cleanliness, to prevent the impact lamp irradiance, if contaminated, wipe the surface with alcohol. Spare lamp should be stored in ventilated and dry non-corrosive environment. Temperature control system temperature control system consists of a black standard thermometer, heater, blower, intelligent instrument, such as the implementation of procedures regulating bodies, using BTHC temperature, which allows the hot air blown into the chamber, so that the test chamber temperature to stabilize. For wet systems for wet system consists of sink, humidification system, etc., through the mechanism of moisture condensation, the sample exposed to moist surface condensation, simulated rain, humidity, condensation and with the sun (UV) to create the best synergy darkness test environment. Equipment running timer device control panel is equipped with a JS20 time relay, smart regulation is within the range of ± 3 ℃ temperature reaches the trial opened, (non-timer is set to 0000, and should be set to a timer off set). Time-control equipment operation and improve the performance of automation equipment. Equipment sample specimen carrying device carrying device located on the UV light radiating evenly, composed by aluminum cabinet pedestal, can carry a total of 22 standard sample (75 mm × 150 mm × 1.5mm). Protection system equipment has water, anti-dry, over-temperature, short circuit and overload protection systems, which are located in the electrical control panel and the cabinet. After entering the alarm state, the device automatically cut off power to the system to work, the equipment stops running and audible prompts, ensuring equipment and personal safety High-day Test Equipment Co., Xiangyang Office phone: 13995754909 Liu Yue group Telephone: 0710-3233006 E-mail: 547622352 @ qq .com Company Website: http: //www.hbgt17.com